...
Python programs run on the robot itself. Take control to run one; STOP ends it for everyone.
Ctrl+S saves, Ctrl+Enter saves and runs. Run starts the saved file.
-- cm
Roll--deg
Pitch--deg
Pi CPU (processor)--°C
Head enclosurenot measured
The CPU sensor is on the Pi board. There is no sensor in the head, so the CPU value says nothing about the head that overheated.
Gaps mean no trusted reading. The CSV holds up to 1 hour, with units in each column name.
Hold to drive, release to stop. Keyboard: focus a button, hold Space.
LEDs start off and are never switched on at startup. Each blink pattern runs in its own thread on the Pi.
Servo calibration is provisional: angles are not measured on this robot yet.
Click sensors to try a pattern. Position = average of the weights [-7, -5, -3, -1, 1, 3, 5, 7] of the sensors that see the line. This uses the Day 2 function, not the robot.
The preview uses the same TSK08 function as the robot.
| Part | State | Why |
|---|
| Setting | Value | Status |
|---|
A web page cannot connect a computer to Wi-Fi. Teammates first join the same network (PC hotspot ASUSPSDLB 0599, password from the owner), then open this link.
Demo mode only. Shows how the page reacts to sensor problems.